Low Sensitivity \ Turn Cap

Are there any plans to introduce more granular control of the look mechanic? My main gripe is the low turn speed. It’s impossible to do a 180, if you take damage from behind you’re already shot 3 times before you can even turn around.

You can tweak your look acceleration and dead-zones.

Look Acceleration

Look Acceleration adjusts the time it takes to hit max look speed when you peg (apply 100% input in any direction) the look stick. The higher the setting, the quicker you will reach top speed, and the lower the setting, the longer it takes to reach top speed.

Inner Dead Zone

The Inner Dead Zone refers to a small region around the analog stick’s center position where we disregard input. Inner Dead Zone is used to prevent drift (camera movement when you aren’t applying any input to the look stick). This is caused because the analog sticks do not always return perfectly to center for a variety of reasons (manufacturing tolerances, wear and tear on the controller, etc). Note that the default we use here aligns with the platform recommended value and is what past Halo games have also used.
Recommended tuning process: Try turning the Inner Dead Zone down to 0% and test if you run into cases where after releasing the look stick, the camera continues drifting. If you do get drift, increase the inner dead zone setting a bit and try again. Ideally, you want as small of a deadzone as possible so that you’re maximizing as much of the analog stick as possible.

Outer Dead Zone

The Outer Dead Zone allows you to adjust the point at which the analog stick registers as hitting 100% input. Outer Dead Zone is used to prevent slow turn (when you are applying 100% input on the look stick but not reaching top look speed). The larger the Outer Dead Zone, the sooner you will hit 100%.
Recommended tuning process: Try turning the Outer Dead Zone down to 0% and test if you run into cases where you can’t hit the “pegged state” and encounter slow turn. If you do get slow turn, increase it a bit more and try again. Note that the majority of cases we found where people were encountering slowturn were somewhat hard to discover as the problem tended to be inconsistent and were often happening only when clenching, torqueing, or rotating the analog stick around the edges a tad. So you might need to experiment with this one a tad more before settling on the proper setting

I’m very aware of the settings on the options screen, I’m looking for the ability to crank the sensitivity higher than 10. It would also be nice to have a separate sensitivity for sniper rifle \ ADS

> 2533274802151032;3:
> I’m very aware of the settings on the options screen, I’m looking for the ability to crank the sensitivity higher than 10. It would also be nice to have a separate sensitivity for sniper rifle \ ADS

I like the idea of a separate scoped and non scoped sensitivity, this should be a thing!

And I agree, I always play 10 sensitivity and this Halo does still feel slow on the 180’s.